Problem with survex

Wookey wookey at wookware.org
Mon Dec 5 10:39:26 GMT 2011


+++ R. Winkler [2011-12-04 14:15 +0100]:

> I've got one problem with survex. When I make an extend-Version from
> a .3d-File
> and try to open it, I get this message.
> Any solutions?

Thanks for spotting that robert.

It would be better if you put the message in the email :-) I wondered
'what message?' for a while.

You should also send bug reports either to the mailing list, or the
bug-repoorting system on Trac
http://survex.com/maillist.html
http://trac.survex.com/
(This stops them getting forgotten about)

Which survex version are you running? ( I suspect version 1.2.2
because line 1545 in version 1.20 is not an assert)

Does it happen with _any_ .3d file?

Can you send us the offending .3d file (or better file it with the bug
in trac)

I can extend a file and display it in Aven fine on survex 1.1.16 on
linux. And I can display that _extend.3d in aven 1.2.2, or reprocess a
new one and it still works fine. So I can't reproduce your problem on
1.1.16 or 1.2.2 on linux. Works fine with small, simple and long,
complex. 

It seems to be blowing up because it's been given a tube with a size
less than 1(and that shouldn't happen) (but I don't actually understand
C++ so could well be confused there). 

Wookey
-- 
Principal hats:  Linaro, Emdebian, Wookware, Balloonboard, ARM
http://wookware.org/



More information about the Survex mailing list